Page 374
MegaRAID SAS Software User GuideAppendix A: Events and Messages
| Event Messages
0x0008 Information Alarm enabled by user
0x0009 Information Background initialization rate changed to %d%%
0x000a Fatal Controller cache discarded due to memory/battery problems
0x000b Fatal Unable to recover cache data due to configuration mismatch
0x000c Information Cache data recovered successfully
0x000d Fatal Controller cache discarded due to firmware version
incompatibility
0x000e Information Consistency Check rate changed to %d%%
0x000f Fatal Fatal firmware error: %s
0x0010 Information Factory defaults restored
0x0011 Information Flash downloaded image corrupt
0x0012 Critical Flash erase error
0x0013 Critical Flash timeout during erase
0x0014 Critical Flash error
0x0015 Information Flashing image: %s
0x0016 Information Flash of new firmware image(s) complete
0x0017 Critical Flash programming error
0x0018 Critical Flash timeout during programming
0x0019 Critical Flash chip type unknown
0x001a Critical Flash command set unknown
0x001b Critical Flash verify failure
0x001c Information Flush rate changed to %d seconds
0x001d Information Hibernate command received from host
0x001e Information Event log cleared
0x001f Information Event log wrapped
0x0020 Fatal Multi-bit ECC error: ECAR=%x, ELOG=%x, (%s)
0x0021 Warning Single-bit ECC error: ECAR=%x, ELOG=%x, (%s)
0x0022 Fatal Not enough controller memory
0x0023 Information Patrol Read complete
0x0024 Information Patrol Read paused
0x0025 Information Patrol Read Rate changed to %d%%
0x0026 Information Patrol Read resumed
0x0027 Information Patrol Read started
0x0028 Information Reconstruction rate changed to %d%%"
0x0029 Information Drive group modification rate changed to %d%%
0x002a Information Shutdown command received from host
0x002b Information Test event: %s
0x002c Information Time established as %s; (%d seconds since power on)
Table 135: Event Messages (Continued)
Number Type Event Text
To Next Page
Loading...
