b. Install the screws to fix the system I/O board into place.
Step 4. (Optional) If you are replacing the system I/O board, install the firmware and RoT security module
that is removed from the old system I/O board onto the new system I/O board. See
“Install the
firmware and RoT security module” on page 130
.
Step 5. Install the SD card. See
“Install the MicroSD card” on page 80.
Step 6. Install the system board assembly into the server.
Figure 104. Installing the system board assembly
a.
Insert the front end of the system board assembly towards the front of the chassis until it
stops.
b.
Lower the other end down into the chassis.
c.
Slide the system board assembly towards the rear of the chassis until it clicks into place.
Ensure that rear connectors on the system I/O board are inserted into the corresponding holes
in the rear panel.
After you finish
1. Install any components that you have removed:
•
“Install a processor” on page 108
• “Install a heat sink” on page 109
• “Install a memory module” on page 83
• “Install the CMOS battery” on page 57
Chapter 5. Hardware replacement procedures 139
To Next Page
Loading...
