Lenovo ThinkSystem SR655 V3 - Page 150

• “Install the system fan cage” on page 147
• “Install a riser assembly” on page 93
• “Install the OCP module” on page 87
2. Push the power supply units in place. Ensure that they are connected to the system board assembly.
3. Reconnect all the required cables to the same connectors on the system board assembly. See
Chapter
6 “Internal cable routing” on page 153
.
4. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside the server.
5. Reinstall the top cover. See
“Install the top cover” on page 150.
6. If the sever was installed in a rack, reinstall the server into the rack. See
“Install the server to rack” on
page 46
.
7. Reconnect the power cords and any cables that you removed.
8. Power on the server and any peripheral devices. See
“Power on the server” on page 42.
9. If the processor board is replaced, update the vital product data (VPD). See
“Update the Vital Product
Data (VPD)” on page 140
.
Machine type number and serial number can be found on the ID label, see
“Identify the server and
access the Lenovo XClarity Controller” on page 31
.
10. Download and install the latest device drivers:
https://datacentersupport.lenovo.com/products/servers/
thinksystem/sr655v3/7d9e/downloads/driver-list/
.
11. Update the system and device firmware. See
“Update the firmware” on page 190.
Note: (Lenovo trained technician only) If you have replaced the firmware and RoT security module,
update the firmware to the specific version supported by the server. See
Tip for replacing a firmware and
RoT security module
.
Update the Vital Product Data (VPD)
Use this topic to update the Vital Product Data (VPD).
• (Required) Machine type
• (Required) Serial number
• (Optional) Asset tag
• (Optional) UUID
Recommended tools:
• Lenovo XClarity Provisioning Manager
• Lenovo XClarity Essentials OneCLI commands
Using Lenovo XClarity Provisioning Manager
Steps:
1. Start the server and press the key according to the on-screen instructions. The Lenovo XClarity
Provisioning Manager interface is displayed by default.
2. Choose System Summary. The “System Summary” tab page is displayed.
3. Click Update VPD, then, follow on-screen instructions to update the VPD.
Using Lenovo XClarity Essentials OneCLI commands
• Updating machine type
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model> [access_method]
140 ThinkSystem SR655 V3 User Guide