A video of this procedure is available at YouTube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BashWCNZQEDP7o3EohXPEV
.
Procedure
Step 1. From the front of the rack, pull the rails all the way out until they stop.
Attention: You can only install the server successfully when the rails are fully extended.
Rack front
Figure 17. Pulling out the rails
Step 2. Carefully lift up the server with three people.
CAUTION:
Make sure three people are lifting the sever by holding the lift points.
Rack front
Figure 18. Lifting up the server
Chapter 5. Hardware replacement procedures 47
To Next Page
Loading...
