1
Lift point
Step 3. From the front of the rack, install the server into the rails.
Rack front
Figure 19. Installing the server into the rails
a.
Tilt the server and slowly lower its rear end; then, push the rails toward the server and make
sure the farthest nailheads on server’s left and right side go into the slots on the rail.
b.
Slowly lower the server down and make sure the other 3 nailheads on server’s left and right
side slip into corresponding slots.
Note: Inspect the sides of the rails to make sure the nailheads are placed in the slots.
Step 4. Slide the server into rack.
48
ThinkSystem SR655 V3 User Guide
To Next Page
Loading...
