Figure 20. Installing the server into the rack
1
Latch
a.
Push up the latches on the rails.
b.
Push the server all the way into the rack until both latches lock into position with a click.
Step 5. (Optional) Secure the server to the rack.
a. Install one M6 screw to each of the rails to secure the server to the rear of the rack.
Rack rear
Figure 21. Securing the server to the rear of the rack
b. Fasten the two thumbscrews located on the front of the server.
Chapter 5. Hardware replacement procedures 49
To Next Page
Loading...
