Function library
Function blocks
9.2.63 Storage block (STORE)
9-206
L
EDSVS9332S-D11 EN 3.0
9.2.63.1 STORE1 control via TP input E5
The trigger signal STORE1-TP-INH indicates a triggering done via the TP input E5 with a HIGH signal
(LOW-HIGH edge at X5/E5). At the same time it is signalled with STORE1-TP-INH that the triggering
is deactivated and must be reset to the active state. This can be done via
z STORE1-RESET = HIGH
z STORE1-ENTP = LOW-HIGH edge
z STORE1-ENWIN = HIGH and the comparison of phase signals
Comparison of phase signals
A phase signal is created from the speed signal at STORE1-MASKI and is compared with the phase
signal at STORE1-MASKV.
If the condition | STORE1-MASKI | ≥ STORE1-MASKV
is fulfilled,
z the TP input E5 is enabled for the next triggering with STORE1-ENWIN = HIGH,
z the integrator for the speed signal at STORE1-MASKI is reset.
To Next Page
Loading...