Lenze EVS 9300 series - Page 415

Function library
Code table
9-289
l
EDSVS9332S-D12 EN 3.0
Code ImportantPossible settings
No. SelectionLenzeLCD
[C0972] RESET 1000 FIXED0 → Selection list 2 MFAIL
Configuration - digital input (reset mains failure
control)
[C0973] ADAPT 1000 FIXED0% →Selection list 1 MFAIL
Adaptation of P-gain of the volta ge controller
[C0974] CONST 1000 FIXED0% →Selection list 1 MFAIL
Adaptation of P-gain of the volta ge controller
[C0975] THRESHOLD 1000 FIXED0% →Selection list 1 MFAIL
Restart protection when the value falls below
the speed threshold
[C0976] NACT 1000 FIXED0% →Selection list 1 MFAIL
Comparison of threshold function
Start for V
2
controller
[C0977] SET 1000 FIXED0% →Selection list 1 MFAIL
Configuration - speed starting value
[C0978] DC-SET 1000 FIXED0% →Selection list 1 MFAIL
Setpoint DC-bus voltage
C0980 MFAIL VP 0.500 0.001 {0.001 } 31.000 MFAIL
Setting of gain V
p
C0981 MFAIL TN 100 20 {1 ms} 2000 MFAIL
Setting of reset time T
n
C0982 MFAIL TIR 2.000 0.001 {0.001 s} 16.000 MFAIL
Setting the acceleration time T
ir
C0983 RETRIGGER T 1.000 0.001 {0.001 s} 60.000 MFAIL
Retrigger time
C0988

-199.99 {0.01 %} 199.99
1 (C0970)
2 (C0973)
3 (C0974)
4 (C0975)
5 (C0976)
6 (C0977)
7 (C0978)
C0989

1 (C0971)
2 (C0972)
[C0990] IN 1000 FIXEDPHI-0 → Selection list 4 PHINT1
Input signal configuration
[C0991] RESET 1000 FIXED0 → Selection list 2 PHINT1
Configuration - reset signal
C0992 (C0990)  -32767 {1 rpm} 32767
C0993 (C0991) 
C0995 DIVISION 0 -31 {1} 31 PHDIV
Divisor in the power-of-two-format (2
C0995
)
[C0996] IN 1000 FIXED0INC → Selection list 3 PHDIV
Input signal configuration
C0997 (C0996)  -2147483647 {1} 2147483647
C1000 DIVISION 1 0 {1} 31 CONVPHA1
Divisor in the power-of-two-format (2
C0995
)
[C1001] IN 1000 FIXED0INC → Selection list 3 CONVPHA1
Input signal configuration
C1002 (C1001)  -2147483647 {1 inc} 2147483647