Lenze L-force 8400 BaseLine D - Page 224

8400 BaseLine D | Software Manual
Index
224 L Firmware 03.00 - DMS EN 5.0 - 07/2009
C481 161, 204
C482 162, 205
C50 182
C51 182
C516 205
C517 206
C52 182
C53 182
C54 183
C56 183
C565 206
C57 183
C574 206
C58 183
C581 207
C59 183
C598 207
C6 176
C600 207
C601 207
C604 208
C606 208
C61 183
C620 161, 162, 208
C621 144, 163, 209
C64 184
C66 184
C7 177
C700 143, 150, 211
C701 143, 144, 146, 150, 212
C725 214
C727 214
C728 214
C73 184
C74 184
C800 151, 214
C801 151, 215
C802 151, 215
C803 151, 215
C804 151, 215
C805 151, 215
C806 216
C81 184
C830 216
C831 216
C833 217
C84 185
C85 185
C87 185
C88 185
C89 185
C90 186
C909 217
C91 186
C910 218
C92 186
C93 186
C94 186
C95 186
C97 187
C98 187
C99 187
C990 218
C991 218
C992 218
C994 218
Cause for quick stop QSP (C00159) 195
Cause of controller inhibit (C00158) 194
Checksums (C00516) 205
Comparison value N_Act (C00024) 180
Conventions used 9
Current switching frequency (C00725) 214
D
Data type 169
DCB
Current (C00036)
181
Hold time (C00107) 188
DC-bus voltage (C00053) 182
Decel. time - main setpoint (C00013) 178
Deceleration time - quick stop (C00105) 187
Delayed resp. to fault
DC-bus overvoltage (C00601)
207
Device commands (C00002) 174
Device settings (C00141) 190
Device state (C00137) 190
Device utilisat. threshold (Ixt) (C00123) 189
Device utilisation (Ixt) (C00064) 184
Digital inputs 116
Digital outputs 118
DIx
Level (C00443)
202
DIx inversion (C00114) 188
DOx
Level (C00444)
203
DOx inversion (C00118) 189
Drive interface 45