Lexmark MX310 - Standard Network Software Error [54]; Standard USB Port Disabled [56]; Supply Needed to Complete Job; Too Many Flash Options Installed [58]

Note: Held jobs that are not restored stay in the printer hard disk and are inaccessible.
Standard network software error [54]
Try one or more of the following:
• From the printer control panel, select Continue to continue printing. For non‑touch‑screen printer
models, press
to confirm.
• Turn
o
the printer and then turn it back on.
• Update the network
firmware
in the printer or print server. For more information, contact customer
support.
Standard USB port disabled [56]
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer models,
press
to confirm.
Notes:
• The printer discards any data received through the USB port.
• Make sure the USB Buer menu is not set to Disabled.
Supply needed to complete job
Do either of the following:
• Install the missing supply to complete the job.
• Cancel the current job.
Too many flash options installed [58]
1 Turn
o
the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra
flash
memory.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Too many trays attached [58]
1 Turn
o
the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra trays.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
7015
Diagnostics and troubleshooting
139