Skewed print check
Actions Yes No
Step 1
Check the guides in the tray where the skewed prints are sourced
from.
Note: If paper is sourced from the MPF, then proceed to
step 9.
Does the position of the guides match the paper loaded?
Go to step 3. Go to step 2.
Step 2
Adjust the guides to match the paper loaded.
Does the problem remain?
Go to step 3. The problem is
solved.
Step 3
Check if the printer supports the paper loaded.
Note: For a complete list of supported paper, see the printer
User’s Guide.
Is the paper supported?
Go to step 5. Go to step 4.
Step 4
Remove the paper, and then load a supported one.
Does the problem remain?
Go to step 5. The problem is
solved.
Step 5
Check the tray pick roller for excess wear and contamination.
Is the pick roller free from excess wear and contamination?
Go to step 7. Go to step 6.
Step 6
Replace the pick roller. See
“Pick roller removal” on page 403.
Does the problem remain?
Go to step 7. The problem is
solved.
7015
Diagnostics and troubleshooting
66
To Next Page
Loading...
