Below is the ACM assembly.
ACM assembly (MX310, MX410) removal
1 Remove the left cover. See “Left cover removal” on page 279.
2 Remove the main drive gearbox. See “Main drive gearbox removal” on page 281.
3 Remove the rear door and cover. See “Rear exit door removal” on page 369 and “Rear cover removal”
on page 370.
4 Remove the power supply. See “Power supply removal” on page 339.
5 Remove the power supply shield. See “Power supply shield removal” on page 340.
6 Remove the duplex. See “Duplex removal” on page 341.
7 Remove the ACM clutch. See “ACM clutch removal (MX310, MX410)” on page 289.
Warning—Potential Damage: Do not cut the cable (leave the ACM clutch hanging).
7015
Parts removal
361
To Next Page
Loading...
