7 Remove the ADF unit.
Installation note: After the new ADF is installed, perform scanner manual registration, see “Scanner manual
registration” on page 244 and scanner calibration, see “Scanner calibration” on page 221.
Scanner assembly removal
1 Remove the rear cover. See “Rear cover removal” on page 370.
2 Open the front access cover.
3 Remove the left cover. See “Left cover removal” on page 279.
4 Remove the right cover. See “Right cover removal” on page 294.
5 Remove the RIP shield from the printer frame assembly. See “Controller board shield removal” on page
301.
7015
Parts removal
390
To Next Page
Loading...
