Network service check
Note: Before starting this service check, print out the network setup page. This page is found under
Menu > Reports > Network Settings. Consult the network administrator to verify that the physical and
wireless network settings displayed on the network settings page for the device are properly
configured. If a wireless network is used, then verify that the printer is in range of the host computer or
wireless access point, and there is no electronic interference. Have the network administrator verify that
the device is using the correct SSID, and wireless security protocols. For more network troubleshooting
information, consult the Lexmark Network Setup Guide.
Actions Yes No
Step 1
If the device is physically connected to the network, verify that the
Ethernet cable is properly connected on both ends.
Is the cable properly connected?
Go to step 3. If the
network is wireless,
then go to step 3.
Go to step 2.
Step 2
Connect the Ethernet cable.
Does this fix the problem.
The problem is
solved.
Go to step 3.
Step 3
Check the printer’s online status under Printers and Faxes on the
host computer. Delete all print jobs in the print queue.
Is the printer online and in a Ready state?
Go to step 5. Go to step 4.
Step 4
Change the printer status to online.
Did this fix the issue?
The problem is
solved.
Go to step 5.
Step 5
Does the IP address displayed on the network settings page match
the IP address in the port of the drivers using the printer?
Go to step 10. Go to step 6.
Step 6
Does the LAN use DHCP?
Note: A printer should use a static IP address on a network.
Go to step 7. Go to step 9.
Step 7
Are the first two segments of the IP address 169.254
Go to step 8. Go to step 9.
Step 8
POR the printer.
Did this resolve the issue?
The problem is
solved.
Go to step 10.
7015
Diagnostics and troubleshooting
211
To Next Page
Loading...
