Flash full service check
Action Yes No
Step 1
Format the flash memory. Navigate to Settings > Print Settings >
Utilities, then select Format Flash.
Does the error remain?
Go to step 2. The problem is
solved.
Step 2
Remove the installed memory, and then POR the machine.
Does the error remain?
Go to step 3. Replace the memory
card.
Step 3
Replace the controller board. See
“Controller board removal” on
page 299.
Does the error remain?
Contact the next
level of support.
The problem is
solved.
Maintenance kit service check
Action Yes No
Replace the maintenance kit and reset the Maintenance counter.
Does the error remain?
Contact the next
level of support.
The problem is
solved.
Insucient
memory service check
Action Yes No
Step 1
Disable the Resource save feature:
Settings > Print Settings > Setup Menu > Resource Save >
O
Does the problem remain?
Go to step 2. The problem is
solved.
Step 2
Check the memory card for proper installation.
Is it properly installed?
Go to step 3. Reseat the memory
card.
7015
Diagnostics and troubleshooting
148
To Next Page
Loading...
