Bottom removals
Power supply removal
1 Remove the left cover. See “Left cover removal” on page 279.
2 Remove the rear door and cover. See “Rear exit door removal” on page 369 and “Rear cover removal”
on page 370.
3 Disconnect the fuser cable (A) from the power supply, and disconnect the cable (B) from the left side of the
printer.
AB
4 Position the printer so that it sits on its right side.
5 Remove the right tray guide. See “Tray guide removal” on page 366.
7015
Parts removal
339
To Next Page
Loading...
