8 Remove the three screws (A).
A
9 Disconnect the cable from the pick/lift motor gearbox.
Tray guide removal
Left guide
1
Remove the rear cover. See “Rear cover removal” on page 370.
2 Remove the left cover. See “Left cover removal” on page 279.
3 Turn the printer on its side (left side down), then remove the three screws (A) from the left guide.
A
Installation note: Before removing the guide, note the position of the ground spring. It will need to be
re‑installed when the guide is re‑installed.
7015
Parts removal
366
To Next Page
Loading...
