5 Remove the scanner front cover. See “Scanner front cover removal” on page 386.
6 Remove the control panel assembly. See “Control panel assembly removal” on page 315.
7 Remove the UICC drip pan.
8 Remove the USB cable bracket. See “USB cable bracket removal” on page 320.
9 Feed the USB cable through the channel on the left side of the printer.
USB wireless cable removal
1 Remove the right cover. See “Right cover removal” on page 294.
2 Remove the RIP board shield. See “Controller board shield removal” on page 301.
3 Remove the fan.
4 Disconnect the MFP wireless cable from the RIP board.
5 Remove the scanner front cover. See “Scanner front cover removal” on page 386.
6 Remove the control panel assembly. See “Control panel assembly removal” on page 315.
7 Remove the UICC drip pan.
8 Lift the wireless control panel cover.
Note: For MX410 machines, two screws (A) must be removed to release the toroid from the cable.
7015
Parts removal
396
To Next Page
Loading...
