13 Rotate, and then remove the 2nd pickup bushing.
14 Pull out the shaft, and remove the ACM.
Pick/lift motor gearbox removal
1 Remove the left cover. See “Left cover removal” on page 279.
2 Remove the rear door and cover. See “Rear exit door removal” on page 369 and “Rear cover removal”
on page 370.
3 Remove the power supply. See “Power supply removal” on page 339.
4 Remove the power supply shield. See “Power supply shield removal” on page 340.
5 Remove the duplex. See “Duplex removal” on page 341.
6 Remove the ACM assembly. See “ACM assembly removal” on page 359.
7 Position the printer so that it sits on its left side.
7015
Parts removal
365
To Next Page
Loading...
