8 Remove the two screws (A) securing the reverse solenoid.
A
ACM clutch removal (MX310, MX410)
1 Remove the left cover. See “Left cover removal” on page 279.
2 Remove the right cover. See “Right cover removal” on page 294.
3 Remove the rear door and cover. See “Rear exit door removal” on page 369 and “Rear cover removal”
on page 370.
4 Remove the power supply. See “Power supply removal” on page 339.
5 Remove the power supply shield. See “Power supply shield removal” on page 340.
6 Remove the duplex. See “Duplex removal” on page 341.
7 Disconnect the cable JF26 from the controller board.
8 Secure right end of the shaft (A) with a pair of needle-nose pliers to prevent it from rotating.
7015
Parts removal
289
To Next Page
Loading...
