Clear Custom Status
Executing this operation erases any strings that have been defined by the user for the default or alternate
custom messages.
To clear the custom status:
1 From the Configuration menu, navigate to Clear Custom Status.
2 Depending on the printer model, press OK or touch Clear Custom Status to proceed.
USB Speed
This setting is used to set the throughput of the USB port on the printer.
Available options:
• Auto
• Full—Forces the USB port to run at full speed and also disables its high‑speed capabilities.
Automatically Display Error Screens
If On, the panel automatically displays any existing printer-related IR after the printer remains inactive on the
home screen for a length of time equal to the Screen timeout setting in the Timeouts section of the General
settings menu. Any IR that appears on the display will give the user the option of returning to the home screen
without clearing it. From the home screen, any other
workflow
or feature can be initiated as usual. Once the
printer returns to the home screen, any existing IR will again appear after the printer remains inactive for a
length of time equal to the Screen timeout setting.
To change this setting:
1 From the
Configuration
menu, navigate to Automatically Display Error Screens.
2 Select from the available options:
• On (default)
• O
3 Depending on the printer model, press OK or touch to save the setting, or press X to return to the
Configuration menu without saving any changes.
USB PnP
In some cases, the USB port at the back of the printer may be incompatible with the chipset in a user’s PC. This
setting lets the user change the USB driver mode to improve its compatibility with these PCs.
Available options:
• 1
• 2
7015
Service menus
251
To Next Page
Loading...
