Trailing edge sensor (MX310, MX410) removal
1 Remove the left cover. See “Left cover removal” on page 279.
2 Remove the right cover. See “Right cover removal” on page 294.
3 Remove the rear door and cover. See “Rear exit door removal” on page 369 and “Rear cover removal”
on page 370.
4 Remove the power supply. See “Power supply removal” on page 339.
5 Remove the power supply shield. See “Power supply shield removal” on page 340.
6 Remove the duplex. See “Duplex removal” on page 341.
7 Disconnect the cable JACM1 from the controller board, and cut it near the frame.
8 Remove the screw (A), and then remove the sensor.
A
9 Remove the other half of the cable from the printer.
Installation notes:
a Install the sensor to the ACM.
b Route the cable along the two cable holders on the side of the ACM.
Note: Make sure that the cable is not loose.
7015
Parts removal
351
To Next Page
Loading...
