h Route the cable using the new path, and secure it with a cable tie (A).
A
Media present sensor flag removal
1 Remove the left cover. See “Left cover removal” on page 279.
2 Remove the rear door and cover. See “Rear exit door removal” on page 369 and “Rear cover removal”
on page 370.
3 Remove the power supply. See “Power supply removal” on page 339.
4 Remove the power supply shield. See “Power supply shield removal” on page 340.
5 Remove the duplex. See “Duplex removal” on page 341.
6 Position the printer so that it sits on its left side.
7 Remove the retainer spring (A).
8 Remove the two springs (B).
7015
Parts removal
355
To Next Page
Loading...
