Lexmark MX310 - 200 Paper Jams

200 paper jams
200 paper jam messages
Notes:
• Some error messages are applicable only to printer models with installed polygon LSU (laser scanning
unit).
• If the sixth digit character assigned to the serial number of the printer is in the P–Z range, then the
printer is installed with a polygon LSU (example: 4514 2ZHH 007CR).
Error code Description Action
200.01 Input sensor covered during warm-up sequence. Go to
“Sensor (input) static jam service check”
on page 100.
200.02 Input sensor covered too quickly. Go to
“Sensor (input) early/late arriving service
check” on page 100.
200.03 Media did not reach input sensor from MPF. Go to
“Sensor (input) early/late arriving service
check” on page 100.
200.05 Input sensor covered too long. Go to
“Sensor (input) early/late arriving service
check” on page 100.
200.07 Input sensor failed to become uncovered from
sheet ahead.
Go to
“Sensor (input) early/late arriving service
check” on page 100.
200.08 Page arrive at input senor at unexpected time. Go to
“Sensor (input) early/late arriving service
check” on page 100.
200.09 Printhead did not receive proper motor feedback
to start laser servo.
Go to
“Sensor (input) image jam service check”
on page 102.
200.10 Printhead motor not locked when media reaches
the input sensor.
Go to
“Sensor (input) image jam service check”
on page 102.
200.11 Printhead motor fell out of lock after page reaches
the input sensor.
Go to
“Sensor (input) image jam service check”
on page 102.
Mirror motor got locked, and then lost it again
before the initial lock timeout.
Go to
“Laser scanning unit (LSU) service check”
on page 152.
200.12 Printhead was not ready for media. Go to
“Sensor (input) image jam service check”
on page 102.
200.13 Media at input sensor is not the next media to be
imaged.
Go to
“Sensor (input) image jam service check”
on page 102.
200.14 Media reached the input sensor before EP was
ready.
Go to
“Sensor (input) image jam service check”
on page 102.
200.15 Image data did not start on time. Go to
“Sensor (input) image jam service check”
on page 102.
200.16 Fuser motor stalled. Go to
“Main drive motor control jam service
check” on page 103.
200.19 Page that was successfully picked from option tray
never reached the input sensor.
Go to
“Sensor (input) early/late arriving service
check” on page 100.
7015
Diagnostics and troubleshooting
98