8 Remove the ground (B), narrow media/bin full sensor (C), and sensor flag (D).
B
C
D
Redrive assembly removal
1 Remove the right cover. See “Right cover removal” on page 294.
2 Remove the left cover. See “Left cover removal” on page 279.
3 Remove the rear door and cover. See “Rear exit door removal” on page 369 and “Rear cover removal”
on page 370.
4 Disconnect cable JNRW1 from the controller board.
5 Remove the two screws (A), and then disconnect the reverse solenoid.
Note: Do not disconnect the reverse solenoid cable from the controller board.
7015
Parts removal
372
To Next Page
Loading...
