3 Remove the three screws (A) securing the control panel assembly to the scanner assembly.
A
4 Lift the control panel assembly, disconnect the ribbon cable JUICC1 from the UICC card, and then feed the
ribbon cable through the wire channel.
Speaker cable removal
1 Remove the left cover. See “Left cover removal” on page 279.
2 Remove the controller board shield. See “Controller board shield removal” on page 301.
3 Remove the fan.
4 Remove the scanner front cover. See “Scanner front cover removal” on page 386.
7015
Parts removal
399
To Next Page
Loading...
