Printer default values U.S. value Non-U.S. value
Paper Sizes setting in the General Settings menu U.S. Metric
Default Paper Size (paper feeding sources which do
not have hardware size sensing capabilities)
Letter A4
Default Envelope Size (envelope feeding sources
which do not have hardware size sensing capability)
10 Envelope DL Envelope
Fax media size Letter A4
PCL Symbol Set PC-8 PC-850
PPDS Code Page 437 850
Universal Units of Measure Inches Millimeters
To change this setting:
1 From the Diagnostics menu, navigate to:
Printer Setup > Defaults
2 Choose U.S. or Non‑U.S.
3 Do one of the following:
• Depending on the printer model, press OK or touch to save any changes.
• Press X to return to the Printer setup menu.
Printed Page Count
The value of this setting gauges the amount of usage on the printer. The value of the Printed Page Count setting
will equal the values of the Picked Sides meter. After all print tests have been completed, the value will reset
to zero.
Note: The value of the setting cannot be changed manually.
Permanent Page Count
The value of this setting indicates the total amount of pages that have been printed. After all print tests have
been completed, the value will reset to zero.
Note: The Permanent Page Count value cannot be reset.
Engine Setting [x]
These settings are used by Engine code ECs to
fix
field
problems. The value of [x] is any value from 1 to 16.
Edge to Edge
When set to On, this shifts all four margins (top, bottom, left, and right) to the physical edge of the page (printable
area of a supported paper size). This feature does not work in PPDS emulation.
7015
Service menus
231
To Next Page
Loading...
