3 Remove the rear door and cover. See “Rear exit door removal” on page 369 and “Rear cover removal”
on page 370.
4 Remove the power supply. See “Power supply removal” on page 339.
5 Remove the power supply shield. See “Power supply shield removal” on page 340.
6 Remove the duplex. See “Duplex removal” on page 341.
7 Disconnect the cable JDUPPI1 from the controller board.
8 Remove the two screws (A), and cut the cable near the frame to detach the sensors.
A
9 Remove the other half of the cable from the printer.
7015
Parts removal
343
To Next Page
Loading...
