Linksys SPA9000 Administration Guide

Linksys Voice System Administration Guide 128
Localizing the SPA400 Caller ID Method
Localization
5. On the menu, click Setup > Voice.
6. Scroll down to the Tear Down FXO port when silence period detected for field, and enter: 0
Refer to the following illustration.
7. Click Save Settings.
8. To restart the SPA400, complete the following steps:
a. Click Administration > Reboot.
b. Click the Restart System button.
c. When the confirmation message appears, click OK. The SPA400 reboots.
d. When the Reboot OK. Go to Setup page?
message appears, click OK.
Localizing the SPA400 Caller ID Method
You need to identify the caller ID method to use in your country.
Note This feature is available in SPA400 firmware version 1.0.1.4.
1. Click Setup tab > Voice.
2. Scroll down to the Line Settings section.
3. From the Caller Id and CP Tone Method drop-down list, choose your region.
NOTE: In the United Kingdom, choose UK BT or UK CCA. In the rest of Europe, choose
European (FSK).
4. Click Save Settings.
5. To restart the SPA400, complete the following steps:
a. Click Administration > Reboot.
b. Click the Restart button.

Linksys SPA9000 Specifications

Physical Interfaces

Ethernet ports	2 10/100BaseT RJ-45
Phone ports	2 RJ-11 FXS
Ring voltage	40-55 VRMS
Ring frequency	10 Hz - 40 Hz
Maximum ringer load	3 REN

Power

On-hook voltage	-50 V NOMINAL
Off-hook current	25 mA min
Terminating impedance	Configurable, including 600 ohms