Linksys Voice System Administration Guide 27
Configuring Basic Settings
Basic Administration of the SPA9000
Setting the Date and Time
The date and time appear on the phone display and are used to activate the daytime and
nighttime Auto Attendant settings. Normally the date and time are set by the network, which
has a connection to an NTP server. If needed, you can identify the NTP server on the Voice >
Wan Setup page, Optional Settings section.
Note Do not use the date/time settings on the Voice > Regional page to set
your system time.
1. Connect to the SPA9000 administration web server, and choose Admin access with
Advanced settings. (See ”Connecting to the SPA9000 Administration Web Server,” on
page 24).
2. Click Router tab > Wan Setup.
3. Scroll down to the Optional settings section.
4. Enter the fully qualified domain name of the NTP server that you want to use, such as
time.nist.gov.
5. Click Submit All Changes.
6. Click Voice tab > Regional.
7. Scroll down to the Miscellaneous section.
8. From the Time Zone drop-down list, choose your local time zone.
9. Click Submit All Changes.
10.
Configuring Daylight Saving Time
You can enter a daylight saving time rule to ensure that the time is adjusted appropriately for
your region.
Syntax and Examples
SYNTAX:
start = <start-time>; end=<end-time>; save = <save-time>
EXAMPLE: start=3/9/7;end=11/2/7;save=1
In this example, Daylight Saving Time begins March 9, 2007, and ends Nov. 2, 2007. One hour is
added to the time of day during this period.
• The <start-time> and <end-time> values specify the start and end dates and times of
daylight saving time. Each value is in the following format: <month> /<day> /
<weekday>[/HH:[mm[:ss]]]