EasyManuals Logo

Linksys SPA9000 Administration Guide

Linksys SPA9000
246 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #107 background imageLoading...
Page #107 background image
Linksys Voice System Administration Guide 105
Working with the Auto Attendant Greetings
Configuring the LVS Auto-Attendant
Recording an Auto Attendant Prompt
Follow this procedure to overwrite an existing recording or to add a new recording.
Note Customized prompts are erased when a factory reset is performed on
the SPA9000.
1. Connect an analog phone to the Phone 1 or Phone 2 port of the SPA9000.
2. Press the star key (*) four times:
****
The IVR plays the following prompt: Linksys configuration menu. Please enter the option
followed by the # (pound) key or hang up to exit.
3. Press 72255# to access the Auto Attendant message settings.
The IVR plays the following prompt: Please enter the message number followed by the #
(pound) key.
4. Enter the number of the message (1 through 10) that you wish to record, review, or delete.
The IVR plays the following prompt: Enter 1 to record. Enter 2 to review. Enter 3 to delete. Enter
* to exit.
5. Press 1 to record a new message.
NOTE: The IVR checks the available buffer size. If there is no more buffer capability, IVR plays
the Option Failed message and returns to the previous menu.
If the buffer space is sufficient, the IVR plays the following prompt: You may record your
message after the tone. When finished, press #.
6. After the tone, record the new message and then press #.
The IVR plays the following prompt: To save, enter 1. To review, enter 2. To re-record, enter 3. To
exit, enter *.
7. Press 1 to save the new recorded message.
The IVR plays the following prompt: One moment, please.
8. Wait for several seconds while the save is completed.

Table of Contents

Other manuals for Linksys SPA9000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Linksys SPA9000 and is the answer not in the manual?

Linksys SPA9000 Specifications

Physical Interfaces IconPhysical Interfaces
Ethernet ports2 10/100BaseT RJ-45
Phone ports2 RJ-11 FXS
Ring voltage40-55 VRMS
Ring frequency10 Hz - 40 Hz
Maximum ringer load3 REN
Power IconPower
On-hook voltage-50 V NOMINAL
Off-hook current25 mA min
Terminating impedanceConfigurable, including 600 ohms

Related product manuals