EasyManuals Logo

Linksys SPA9000 Administration Guide

Linksys SPA9000
246 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
Linksys Voice System Administration Guide 46
Configuring Line Interfaces on the SPA9000
Configuring Phone Lines and Calling Routing Behavior
If the device is a fax machine, disable echo cancelling. On the FXS N page, Audio
Configuration section, set the FAX Disable ECAN field to yes. Also make sure that the
Preferred Codec is set to G.711u (default setting).
4. Enter the Dial Plan settings, as needed. See Configuring Dial Plans,” on page 52.
5. Click Submit All Changes.
Configuring Line Interfaces on the SPA9000
You can configure the following types of services on the SPA9000 line interfaces:
ITSP service: Up to 16 DID numbers can be supported on each line interface. You can
configure different ITSP accounts on different line interfaces.
PSTN service: You can configure a line interface to register the SPA9000 with a SPA400
to support PSTN lines.
SPA400 voice mail service: You can configure a line interface to register the SPA9000
with a SPA400 to support voice mail server. This SPA400 should have no more than two
PSTN lines connected. If more than two PSTN lines and voice mail are required, you
should reserve one SPA400 exclusively for voice mail. Exceeding these guidelines will
affect the quality of voice mail playback and command recognition.
ISDN services: You can configure a line interface to register the SPA9000 with a
Mediatrix® 4400 ISDN BRI Digital gateway. For more information, refer to the SPA9000/
Mediatrix® 440X ISDN Gateway Configuration Guide, available at www.linksys-itsp.com
(for Europe, Middle East and Africa Service Providers) and www.linksys-voip.eu (for
Europe, Middle East and Africa Value Added Resellers).
This section includes the following topics:
Configuring a Line Interface for ITSP Service,” on page 46
Configuring a Line Interface for a SPA400 (PSTN or Voice Mail),” on page 48
Configuring Call Capacity for a Line Interface,” on page 51
Configuring a Line Interface for ITSP Service
1. Connect to the SPA9000 administration web server, and choose Admin access with
Advanced settings. (See ”Connecting to the SPA9000 Administration Web Server,” on
page 24.)
2. Click Voice tab > Line N, where N represents the line interface number.
3. From the Line Enable drop-down list, choose yes.
4. Enter the account information for your ITSP account:
User ID: The account number or logon name for your ITSP account (often the same as the phone
number)

Table of Contents

Other manuals for Linksys SPA9000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Linksys SPA9000 and is the answer not in the manual?

Linksys SPA9000 Specifications

Physical Interfaces IconPhysical Interfaces
Ethernet ports2 10/100BaseT RJ-45
Phone ports2 RJ-11 FXS
Ring voltage40-55 VRMS
Ring frequency10 Hz - 40 Hz
Maximum ringer load3 REN
Power IconPower
On-hook voltage-50 V NOMINAL
Off-hook current25 mA min
Terminating impedanceConfigurable, including 600 ohms

Related product manuals