Linksys Voice System Administration Guide 88
Configuring a SPA400 for Voice Mail Service
Administering the SPA400 and Voice Mail Service
• ”Configuring Local Voice Mail Service on a SPA400,” on page 88
• ”Setting Up Voice Mail on Each Station,” on page 90
• ”Enabling Remote Voice Mail Access (Optional),” on page 93
Voice Mail Capacity
The provided 128-Mb USB drive can store more than 3.8 hours of messages (approximately 230
60-second messages). For example, with 10 voice mail users, each user can store up to 23 60-
second messages. When disk capacity is reached, inbound voice mail deposit attempts are
disconnected. If additional voice mail storage is required, please contact Linksys for
recommended high-capacity USB drives.
Configuring Local Voice Mail Service on a SPA400
You need to configure the voice mail server and set up the voice mail boxes for the users.
NOTE: The settings on this page correspond to the settings on the SPA9000 Voice > Line page.
See ”Configuring a Line Interface for a SPA400 (PSTN or Voice Mail),” on page 48.
1. Connect to the SPA400 administration web server. (See ”Connecting to the SPA400
Administration Web Server,” on page 80.)
2. Click Setup tab > Voicemail Server.
3. Enter the following information:
• Server Port: 5090
The voice mail server uses this UDP port to listen for signalling between the SPA400 and
the SPA9000. This port must be different from the port number that you entered on the
SPA9000 Interface page.
• SPA9000 subscriber ID: 8888
The SPA9000 uses the subscriber ID to subscribe to the SPA400 Voice mail Server for
obtaining notification.
• Mailbox deposit number: 900
The SPA9000 uses the deposit number to deposit voice mail on the voice mail server.
• Mailbox manage number: 800
The SPA9000 uses the deposit number to access voice mail on the voice mail server.
To Next Page
Loading...
Need help?
Physical Interfaces
Power
