Linksys SPA9000 Administration Guide

Linksys Voice System Administration Guide 209
Administration
Setup tab
Voicemail Users
Administration
This section describes the fields on the following pages within the Administration module:
•
”Management,” on page 209
• ”Factory Default,” on page 210
• ”USB Setting,” on page 210
• ”Firmware Upgrade,” on page 210
• ”Reboot,” on page 210
Administration tab
Management
User Setting
Enable User N Enables the mailbox
Notes: Each mailbox can be assigned to a client station that is
managed by the SPA9000. Before a station can deposit and access
voicemail, the mail box ID must be configured through the Ext N page.
User ID The mailbox ID
Password The password for the mailbox
Gateway Access
Local Access
Gateway Username The user name that is entered to log on to the SPA400 web
configuration utility (default = Admin)
Gateway Password The password that is entered to log on to the SPA400 web configuraton
utility (default = blank)
Re-enter to Confirm If you entered a new password, retype it in this field.

Linksys SPA9000 Specifications

Physical Interfaces

Ethernet ports	2 10/100BaseT RJ-45
Phone ports	2 RJ-11 FXS
Ring voltage	40-55 VRMS
Ring frequency	10 Hz - 40 Hz
Maximum ringer load	3 REN

Power

On-hook voltage	-50 V NOMINAL
Off-hook current	25 mA min
Terminating impedance	Configurable, including 600 ohms