EasyManuals Logo

Linksys SPA9000 Administration Guide

Linksys SPA9000
246 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
Linksys Voice System Administration Guide 34
Using the Interactive Voice Response Unit
Basic Administration of the SPA9000
”Using the IVR Menu,” on page 34
”Entering a Password through the IVR,” on page 37
Using the IVR Menu
To use the IVR menu, complete the following steps.
1. Connect an analog telephone to the Phone 1 or Phone 2 port of the SPA9000.
2. Press **** (quickly press the star key four times).
3. Wait until you hear “Linksys configuration menu.
4. Refer to Table 2-1 to identify the option required.
5. Enter the required option followed by the # (pound) key.
NOTE:
To enter a period, use the star key (*).
When entering a value, such as an IP address, to exit without entering any changes,
press the * (star) key twice within half a second. Otherwise, the * is treated as a decimal
point.
After entering a value, such as an IP address, press the # (pound) key to indicate you
have finished your selection.
To save a new setting, press 1. To review a new setting, press 2. To re-enter a setting,
press 3. To cancel your entry and return to the main menu, press * (star).
For example, to enter the IP address 191.168.1.105 by keypad, press the following keys:
191*168*1*105. Press the # (pound) key to indicate that you have finished entering the
IP address. Then press 1 to save the IP address, or press the * (star) key to cancel your
entry and return to the main menu.
If the menu is inactive for more than one minute, the SPA9000 times out. You need to re-
enter the menu by pressing ****.
6. To exit the menu, hang up the telephone.
The settings that you have saved take effect after you hang up the telephone. The SPA9000
may reboot at this time.

Table of Contents

Other manuals for Linksys SPA9000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Linksys SPA9000 and is the answer not in the manual?

Linksys SPA9000 Specifications

Physical Interfaces IconPhysical Interfaces
Ethernet ports2 10/100BaseT RJ-45
Phone ports2 RJ-11 FXS
Ring voltage40-55 VRMS
Ring frequency10 Hz - 40 Hz
Maximum ringer load3 REN
Power IconPower
On-hook voltage-50 V NOMINAL
Off-hook current25 mA min
Terminating impedanceConfigurable, including 600 ohms

Related product manuals