Linksys SPA9000 Administration Guide

Linksys Voice System Administration Guide 141
Advanced Topics for SPA400 Voice Mail Service
Configuring Outbound Call Codec Selection Codes
A user can enter a code selection code before dialing a number, to choose the preferred codec
for the associated call.The LVS is pre-configured with default codec selection codes, but you
can customize them for your site. The codes are automatically appended to the dial plan.
To select a specific codec per call, the phone user enters the code before entering the
telephone number.
1. Connect to the SPA9000 administration web server, and choose Admin access with
Advanced settings. (See ”Connecting to the SPA9000 Administration Web Server,” on
page 24).
2. Click Voice tab > Regional.
3. Scroll down to the Outbound Call Codec Selection Codes section.
SPA9000 Voice > Regional: Outbound Call Codec Selection Codes
4. Edit the codes, as needed.
5. Click Submit All Changes.
Advanced Topics for SPA400 Voice Mail Service
On the SPA9000, accessing a voicemail server to check or deposit voicemail is similar to calling
an external number, or being call forwarded to an external number. Each line interface can use
a different voicemail server.
There are three groups of voicemail operations:
• Depositing voicemail
• Managing voicemail from a client station or from an external number
• Subscription to voicemail notification and receiving voicemail notification
SPA9000 assumes that a voicemail account can include more than one mailbox ID (MBID). The
voicemail account is defined with a user-ID, which can be the same as the line interface user-ID.

Linksys SPA9000 Specifications

Physical Interfaces

Ethernet ports	2 10/100BaseT RJ-45
Phone ports	2 RJ-11 FXS
Ring voltage	40-55 VRMS
Ring frequency	10 Hz - 40 Hz
Maximum ringer load	3 REN

Power

On-hook voltage	-50 V NOMINAL
Off-hook current	25 mA min
Terminating impedance	Configurable, including 600 ohms