Linksys SPA9000 Administration Guide

Linksys Voice System Administration Guide 37
Using the Interactive Voice Response Unit
Basic Administration of the SPA9000
Note The items marked with “Requires Password” only require a password if
the Administrator password is set.
Entering a Password through the IVR
To input the password using the phone keypad, the following translation conventions
apply:
– To input: A, B, C, a, b, c—press “2’
– To input: D, E, F, d, e, f—press “3’
– To input: G, H, I, g, h, i—press “4’
– To input: J, K, L, j, k, l— press “5’
– To input: M, N, O, m, n, o—press “6’
– To input: P, Q, R, S, p, q, r, s—press “7’
User Factory Reset
of Unit
WARNING:
ALL “User-
Changeable”
NON-DEFAULT
SETTINGS WILL BE
LOST!
This might include
network and
service provider
data.
877778 Enter 1 to confirm
Enter *(star) to cancel
operation
SPA prompts for confirmation.
After confirming, you hear
“Option Successful.” Hang up.
Unit reboots and all “User
Changeable” configuration
parameters are reset to factory
default values.
Factory Reset of
Unit
WARNING:
ALL NON-DEFAULT
SETTINGS WILL BE
LOST!
This includes
network and
service provider
data.
73738 Enter 1 to confirm
Enter * (star) to cancel
operation
SPA prompts for confirmation.
After confirming, you hear
“Option Successful.” Hang up.
Unit reboots and all
configuration parameters are
reset to factory default values.
Table 2-1 IVR Options (Continued)

Linksys SPA9000 Specifications

Physical Interfaces

Ethernet ports	2 10/100BaseT RJ-45
Phone ports	2 RJ-11 FXS
Ring voltage	40-55 VRMS
Ring frequency	10 Hz - 40 Hz
Maximum ringer load	3 REN

Power

On-hook voltage	-50 V NOMINAL
Off-hook current	25 mA min
Terminating impedance	Configurable, including 600 ohms