Linksys SPA9000 Administration Guide

Linksys Voice System Administration Guide 38
Using the Interactive Voice Response Unit
Basic Administration of the SPA9000
– To input: T, U, V, t, u, v—press “8’
– To input: W, X, Y, Z, w, x, y, z—press “9’
– To input all other characters in the Administrator account password, press “0’
Note This translation convention only applies to the password input.
For example, to input password test#@1234 by phone keypad, you need to press the
following sequence of digits: 8378001234.
1. After entering a value, press the # (pound) key to indicate end of input.
• To save value, press 1.
• To review the value, press 2.
• To re-enter the value, press 3.
• To cancel the value entry and return to the main configuration menu, press
*’ (star).
NOTES:
– The final # key is not included in the password value.
– Saved settings take effect when the telephone is hung-up, and if necessary, the
SPA9000 automatically reboots.
2. After one minute of inactivity, the unit times out. The user needs to re-enter the
configuration menu from the beginning by pressing * * * *.

Linksys SPA9000 Specifications

Physical Interfaces

Ethernet ports	2 10/100BaseT RJ-45
Phone ports	2 RJ-11 FXS
Ring voltage	40-55 VRMS
Ring frequency	10 Hz - 40 Hz
Maximum ringer load	3 REN

Power

On-hook voltage	-50 V NOMINAL
Off-hook current	25 mA min
Terminating impedance	Configurable, including 600 ohms