Linksys Voice System Administration Guide 154
Router Tab
• ”VLAN Settings section,” on page 155
Router tab > Wan Setup page >
Internet Connection Settings section
Router tab > Wan Setup page >
Static IP Settings section
Router tab > Wan Setup page >
PPPoE Settings section
Router tab > Wan Setup page >
Optional Settings section
Connection Type IP address assignment scheme, static or DHCP.
Static IP Static IP address of SPA9000, which takes effect if DHCP is disabled.
Default: 0.0.0.0
NetMask The NetMask used by SPA9000 when DHCP is disabled.
Default: 255.255.255.0
Gateway The default gateway used by SPA9000 when DHCP is disabled.
Default: 0.0.0.0
PPPoE Login Name The account name assigned by the ISP for connecting on a Point-to-
Point Protocol over Ethernet (PPPoE) link.
PPPoE Login Password The password assigned by the ISP for connecting on a Point-to-Point
Protocol over Ethernet (PPPoE) link.
PPPoE Service Name The service name assigned by the ISP for connecting on a Point-to-Point
Protocol over Ethernet (PPPoE) link.
HostName The host name of the SPA9000
Domain The network domain of the SPA9000.
Primary DNS The DNS server that is used by the SPA9000
NOTE: When DHCP is enabled, you can enter the IP address of a DNS
server in addition to DHCP-supplied DNS servers. When DHCP is
disabled, enter the primary DNS server. Default: 0.0.0.0
Secondary DNS The DNS server that is used by the SPA9000
NOTE: When DHCP is enabled, you can enter the IP address of a DNS
server in addition to DHCP-supplied DNS servers. When DHCP is
disabled, enter the primary DNS server. Default: 0.0.0.0
DNS Server Order The method for selecting the DNS server: Manual, Manual/DHCP, and
DHCP/Manual
To Next Page
Loading...
Need help?
Physical Interfaces
Power
