Linksys SPA9000

Linksys Voice System Administration Guide 188
Voice tab
FXS Port Input Gain Input gain in dB, up to three decimal places. The range is 6.000 to -
12.000.
Default: -3.
FXS Port Output Gain Output gain in dB, up to three decimal places. The range is 6.000 to -
12.000. The Call Progress Tones and DTMF playback level are not
affected by the <FXS Port Output Gain>.
Default: -3
DTMF Playback Level Local DTMF playback level in dBm, up to one decimal place.
Default: -16.0
DTMF Playback Length Local DTMF playback duration in milliseconds.
Default: .1
Detect ABCD To enable local detection of DTMF ABCD, select yes. Otherwise, select
no. Setting has no effect if DTMF Tx Method is INFO; ABCD is always sent
OOB regardless in this setting.
Default: yes
Playback ABCD To enable local playback of OOB DTMF ABCD, select yes. Otherwise,
select no.
Default: yes
Caller ID Method The following choices are available:
Bellcore (N.Amer,China)—CID, CIDCW, and VMWI. FSK sent after first ring
(same as ETSI FSK sent after first ring) (no polarity reversal or DTAS).
DTMF (Finland, Sweden)—CID only. DTMF sent after polarity reversal
(and no DTAS) and before first ring.
DTMF (Denmark)—CID only. DTMF sent after polarity reversal (and no
DTAS) and before first ring.
ETSI DTMF—CID only. DTMF sent after DTAS (and no polarity reversal)
and before first ring.
ETSI DTMF With PR—CID only. DTMF sent after polarity reversal and
DTAS and before first ring.
ETSI DTMF After Ring—CID only. DTMF sent after first ring (no polarity
reversal or DTAS).
ETSI FSK—CID, CIDCW, and VMWI. FSK sent after DTAS (but no polarity
reversal) and before first ring. Waits for ACK from CPE after DTAS for
CIDCW.
ETSI FSK With PR (UK)—CID, CIDCW, and VMWI. FSK is sent after polarity
reversal and DTAS and before first ring. Waits for ACK from CPE after
DTAS for CIDCW. Polarity reversal is applied only if equipment is on
hook.
Default: Bellcore(N.Amer, China)
Caller ID FSK Standard The SPA9000 supports bell 202 and v.23 standards for caller ID
generation. Select the FSK standard you want to use, bell 202 or v.23.
Default: bell 202
Feature Invocation Method Select the method you want to use, Default or Sweden default.
Default: Default
More Echo Suppression Enable or disable more echo suppresion.
Default: no