Linksys SPA9000 Administration Guide

Linksys Voice System Administration Guide 91
Configuring a SPA400 for Voice Mail Service
Administering the SPA400 and Voice Mail Service
SPA9000 PBX Status
3. Find the phone that you want to configure, and then click the hyperlink in the IP Address
column. The Telephone Configuration page appears in a separate browser window.
SPA9xx Telephone Configuration > Info
4. To assign a station name, complete the following steps:
a. Click the Phone tab.
b. In the General section, type a name in the Station Name field.
SPA9xx Telephone Configuration > Phone: General
NOTE: This setting assists you in managing the phones. The station name appears on
the phone display, in the Corporate Directory, and in features such as Group Call Pickup,
that list the participating phones in a menu.

Linksys SPA9000 Specifications

Physical Interfaces

Ethernet ports	2 10/100BaseT RJ-45
Phone ports	2 RJ-11 FXS
Ring voltage	40-55 VRMS
Ring frequency	10 Hz - 40 Hz
Maximum ringer load	3 REN

Power

On-hook voltage	-50 V NOMINAL
Off-hook current	25 mA min
Terminating impedance	Configurable, including 600 ohms