363-206-285 Detailed Level Procedure: DLP-528
Issue 2, February 2000 Page 1 of 12
DDM-2000 OC-3 MULTIPLEXER
Install New IMA LAN Software Generic Program
In-Service System
Remote Shelf Download
1. Before beginning the software installation, refer to the Software Installation
and Upgrade Procedure section of the Software Release Description. This
section contains a description of any special considerations required when
installing this version of software.
2.
NOTE:
This procedure uses the cpy-prog: or ins-prog: commands to install
a new software program in a remote in-service DDM-2000 OC-3 shelf. It
is assumed that the local shelf has already been upgraded and the
software is running normally or has been installed as a dormant copy. For
procedures to download software locally to a shelf, see DLP-525.
NOTE:
Starting with OC-3 Release 15.0, if a cpy-prog: or ins-prog:
command is issued; in addition to the TID, the user will be prompted for
Program Type with a value of either nesw (for NE software generic) or
lansw (for IMA LAN software generic).
NOTE:
The new command format for cpy-prog: is
cpy-prog:tid,pgmtype=lansw; and for ins-prog is
ins-prog:tid,pgmtype=lansw; where the TID entered is that of the
remote shelf where you want to install the new software.
Verify that no DCC failures or transmission failures (OC-3 LOS, flashing OLIU
FAULT LEDs, etc.) are present on the network element or system receiving the
program.
3. Use rtrv-fecom/set-fecom command to verify/enable far-end
communications (fecom).
DLP-525
To Next Page
Loading...
Need help?
General
