DLP-532: Detailed Level Procedure 363-206-285
Page 3 of 14 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
NOTE:
If a linear shelf is in the STS3c mode (concat mode enabled by the
set-oc3: command) and a different software generic that does not
have the STS3c feature is loaded, the OLIUs will stay in the concat
mode until they are removed and reseated.
NOTE:
If the ins-prog: command is used for software upgrades from
non-TARP Release 9.1 or later, the software is loaded as a dormant copy
in the SYSCTL receiving the software. At the end of the download, the
rtrv-alm: report will show a status message of
dormant/exec code mismatch.Theapply: command must be
used to overwrite the original executing copy of software with the new
dormant software version. See the Commands and Reports section in
Volume 1 of this manual for a description of the apply: command.
Before performing this procedure, ensure that both TGS/TG3 circuit packs are
installed in the shelf, then use the
switch-sync:s=circuitpack,pri=manual command to switch to the
protection TGS/TG3 circuit pack in TIMING slot 2, if not already ACTIVE.Use
rtrv-sync: command to verify that the protection TGS/TG3 circuit pack in
TIMING slot 2 is ACTIVE.
4.
NOTE:
If you are using a PC operating in a
Windows
*
environment, you must
exit
Windows
and restart your PC in
MS-DOS
mode before performing
these download procedures. For example, if your PC is running
Windows
95
you must exit
Windows
by clicking on the Start button, then Shut
Down, then Restart the computer in
MS-DOS
mode.
Obtain equipment, check software, and connect PC for download.
Reference: DLP-566
* Registered trademark of Microsoft Corporation.
DLP-566
To Next Page
Loading...
Need help?
General
