Lucent Technologies DDM-2000 OC-3 User Manual

DLP-541: Detailed Level Procedure 363-206-285
Page 2 of 8 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
4.
NOTE:
Initially, the default for the privileged user password is DDM-2000;
however, this default may have been changed.
NOTE:
Passwords are not displayed on the CIT.
At the password< prompt, enter a valid privileged user password (provided by
your DDM-2000 administrator).
Response: CIT prints the following message followed by an alarm
and status report:
5.
NOTE:
After the prompt ( < ), the system will respond to commands entered. The
set-link:pg=( ) commandmaybeusedtosettheverticalsizeofthe
displayed page on the CIT. Page (pg) length may be set from 3 to 150
lines with a default length of 24 lines.
Did you use the default privileged user login (LUC01, LUC02, or LUC03) and
password (DDM-2000) to log into the system?
If YES, continue with Step 6.
If NO, proceed to Step 8.
/*************************************
**
* Lucent Technologies *
* DDM-2000 OC-3 Multiplexer *
**
* Release a.b.c *
**
*************************************/
.
.
.
TID date time
M rtrv-alm:all COMPLD
/* Active Alarms and Status Report

Lucent Technologies DDM-2000 OC-3 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-3
Category	Multiplexer
Language	English