363-206-285 Detailed Level Procedure: DLP-541
Issue 2, February 2000 Page 7 of 8
DDM-2000 OC-3 MULTIPLEXER
17.
NOTE:
After the prompt (<), the system will respond to commands entered. The
set-link:pg=( ) command may be used to set the vertical size of the
displayed page on the CIT. Page (pg) length may be set from 3 to 150
lines with a default length of 24 lines.
NOTE:
There are four types of users:
General
users may execute any commands that are not restricted to
privileged users.
Maintenance
users may execute commands that obtain
nonprivileged system reports, perform protection switching, loopback
activities, and perform some other maintenance activities.
Privileged
users may execute any command, including restricted
commands.
Reports-only
users may only execute commands that obtain
nonprivileged system reports.
Refer to
Security
in the Administration and Provisioning section of this
manual for more information about restricted commands.
NOTE:
Three privileged and up to 100 nonprivileged (general, maintenance,
and/or reports-only) logins are supported. If a user attempts to enter
another login when the maximum supported logins already exist, the
command will be denied.
NOTE:
The three privileged user logins may be edited to change the login name
and/or password, but privileged user logins cannot be added or deleted.
See the Commands and Reports section of this manual for a description
of the set-lgn: command format.
Use the set-lgn: command to edit, delete, or enter logins/passwords and
user types, as required.
To Next Page
Loading...
Need help?
General
