The Bluetooth
®
icon in the information bar at the bottom of the display should change from flashing and become
permanently on, as below:
Fig 56: Permanently ON
Connection between the MFT-X1 and CertSuite™ is complete.
16.5 Failure to connect
If the MFT-X1 fails to connect to the mobile device check the following:
The MFT-X1 serial number matches that on the instrument
Mobile device Bluetooth
®
is active
MFT-X1 Bluetooth
®
icon is flashing
The mobile device can see the MFT-X1 in the available device listing
The MFT is close to the mobile device (for connection purposes)
If the instrument fails to connect to the mobile platform, contact Megger Technical Services for assistance or contact
the CertSuite team via the web site: CertSuite.info.
16.6 Sleep mode and power cycling the MFT-X1
The MFT-X1 can drop into a sleep mode after 5 minutes or longer depending on the time set in the general settings
on the instrument. If this happens the connection to the MFT-X1 will be lost.
Likewise, if the Instrument is turned off the connection will be lost.
In both cases the green MFT Icon in the CertSuite™ application will turn red, indicating loss of connection.
The Bluetooth
®
icon on the MFT Information bar will also start flashing.
In sleep mode, pressing the test button on the instrument will wake it and automatically re-connect to the
mobile device.
The same applies to the power off function. Switching the unit back on should automatically reconnect the
Instrument to the mobile device.
Should the reconnection fail then press the down arrow on the red icon in CertSuite™, select the instrument from
the list and the instrument should re-connect.
www.megger.com MFT-X1
91
Download results to a remote device
To Next Page
Loading...
Need help?
General
