Section 2 - Setup and Calibration
90-8M0070299 eng MAY 2012 Page 9
Import Configuration (Optional)
IMPORTANT: The import configuration option is used to import configuration settings that were saved to a USB memory stick.
The VesselView unit will recognize USB memory sticks of version 1.1 or 2.0 that is stated to be backwards compatible to
version 1.1. The VesselView unit will not recognize memory sticks that are only version 2.0 compatible.
IMPORTANT: Configuration settings saved to a USB memory stick are compiled into one data file. Only one file can exist in the
root of the USB memory stick. VesselView will not recognize multiple import files.
1. The "IMPORT CONFIG" screen instructs you to insert a USB memory stick and wait for instructions.
IMPORT CONFIG
TO IMPORT CONFIGURATION, INSERT
MEMORY STICK AND WAIT FOR INSTRUCTIONS.
27304
2. Insert a USB memory stick into the USB port on the back of the VesselView unit.
a - Ethernet port (for future option)
b - USB port
c - USB memory stick
IMPORTANT: Do not remove the USB memory stick until the import process is complete.
3. When the memory stick is detected, the "IMPORT CONFIG" screen will display "MEMORY STICK READY."
IMPORTANT: If you attempt to load a configuration setting that was not saved to the USB memory stick, the import of the
data file will not be successful and a yellow pop‑up message will appear stating "IMPORT UNSUCCESSFUL." If you can
recall the configuration setting that was not saved, select "SKIP" for that particular configuration setting. That particular
configuration setting will need to be setup and calibrated accordingly.
To Next Page
Loading...
Need help?
General
