Section 2 - Setup and Calibration
90-8M0070299 eng MAY 2012 Page 25
3.
Press the check button to confirm that you have trimmed all engines or drives to the full down position, or press the "X"
button to go back one step. This sets the "0.0" trim setting.
4. When the "TRIM ENGINE" box prompts you to trim "UP," trim all engines or drives up, but not to the trailer position. This
will display a "10.0" trim setting.
5.
Press the check button to confirm that you have trimmed all engines or drives up to the "10.0" position, or press the "X"
button to go back one step.
6. When the "TRIM ENGINE" box prompts you to trim to "MAX," trim all engines or drives all the way up to the trailer position.
This will display a "25.0" trim setting.
7.
Press the check button to confirm that you have trimmed all engines or drives to the trailer position, or press the "X" button
to go back one step. VesselView will display the saving settings screen and restart.
NOTE: After any change or customization to the VesselView configuration, a blue pop‑up message will appear as a
reminder to save the session. It is recommended that all session changes be saved before holding the "
X
" button while
keying all engines off. Refer to
Section 1
‑
Saving the Settings
.
Configuration
NOTE: A configuration of the vessel does not need to be performed if the vessel has been configured using the setup wizard.
To Next Page
Loading...
Need help?
General
