Section 5 - Propulsion Menu
90-8M0070299 eng MAY 2012 Page 85
5. Press the check button to exit the edit mode.
6. Move the remote control handle to the WOT position to reach the RPM set point.
Setting Smart Tow Launch Control
IMPORTANT: Do not leave the helm while using Smart Tow launch control.
1. From the "SMART TOW" screen, press the check button to activate the RPM set point box.
2. Use the left and right arrow buttons to set a maximum RPM.
3. Press the down arrow to activate the Smart Tow status box.
4. Press the left or right arrow button to set the status from "ENABLED" to "LAUNCH."
5. Press the down arrow to activate the "LAUNCH CONTROL" box.
6. Press the left or right arrow button to select the launch profile best suited to your towing application. Five profiles are
available ranging from the least aggressive acceleration (Profile 1) to the most aggressive acceleration (Profile 5).
Launch profiles
7. Press the check button to exit the edit mode.
8. Move the throttle to WOT to begin the launch. The "STATUS" box displays "ACTIVE" while the launch is in progress.
To Next Page
Loading...
Need help?
General
