Microplex LOGIJET TC8 - Page 103

Panel Functions 103
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
Panel display
[ON LINE ]
[Menu Level 1 ]
  
[Engine ]
[Printspeed ]
  
[Slip Menu ]
[Testpage DIN A4 ]
  
[Slip Correction ]
[ 35 ]
  
[ 25 ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
Press the NEXT or PREVIOUS key until
[Engine ] is displayed.
Press the ENTER key. This selects the
Engine menu.
Press the NEXT or PREVIOUS key until
[Slip Menu] is displayed.
Press the ENTER key. This selects the
Slip Menu.
Press the NEXT or PREVIOUS key until
[Slip Correction] is displayed.
The panel function Slip Correction is
selected.
The currently set value is displayed.
Please add your new slip correction
considering the signs (in this example
we have to add -10 to 35).
(Operating the NEXT or PREVIOUS key
changes the Slip correction value.)
Now the new correction setting is
saved.
In addition this new value can be saved
as setup value (using the ENTER key).
After this decision turn the printer ON
LINE again: Press the ON LINE key
longer than 2 seconds.